Railgun    (1)  

 

 

Railgun -  (1 copy)   This item is 3D printed in resin.

Due to their length these items might warp slightly during shipping due to summer heat. If this occurs you can straighten them by heating them in a cup of hot water for 30-60 seconds (coffee or tea hot). The heat will soften the resin allowing you to gently bend it back into proper position, as it cools the resin will harden and hold its shape. Do not bend the piece without warming it first as it will cause the resin to snap. 

 

(Model shows additional Two Row Missile Launchers being used which are not included)

 

Measures approximately 74mm long.

 

This part is made from 3D printed resin and is supplied unpainted and unassembled, color may vary from the picture. 

Games Workshop Tau Crisis Suit is not included and is only shown to illustrate the scale & size of the part.This item is not a toy and is not intended for children under the age of 12.

 

Some minor clean up and flash removal may be needed. It is suggested that you wash resin parts in soapy water with a mild dishsoap to remove any left over release agents and oils prior to painting.

 

Excessive heat may damage resin products. Do not leave resin parts in hot areas (such as a car) or in direct sunlight as it may damage the model or cause the parts to warp. Warped resin items can usually be straightened by soaking the part in a cup of hot water (not boiling) until it becomes soft, then carefully bending the part back into proper shape then allowed to cool.